Question
A galvanometer cannot be used directly to measure current - why ? Explain the solution of this problem.
###
State the difficulties occured and their solution when galvanometer is directly used as ammeter.

Answer

There are two reasons why a galvanometer cannot be used directly as an ammeter

Image
(i) Galvanometer is a very sensitive device. It also shows the full scale deflection for a current of the order of $\mu A$.
(ii) To measure current, a galvanometer has to be connected in series but its resistance is high, so that it changes the value of the current flowing in the circuit.
To overcome these difficulties, a small resistance called a shunt is connected to the galvanometer.
The shunt is connected in parallel with the galvanometer. Due to this, most of the current passes through the shunt.
The resistance of this arrangement is $=\frac{R_{ G } r_{ S }}{ R _{ G }+r_{ S }}$ But $R _{ G } \gg r_{ S }$
So, we can neglect $r_{ S }$ as compared to $R _{ G }$
So, $\frac{ R _{ G } r_{ S }}{ R _{ G }} \approx r_{ S }$
Since, the value of $r_{ S }$ very small, the original current does not change and the true value of current can be measured.

Need a full question paper?

Generate a complete, print-ready paper with questions like this in minutes — across 16+ boards, with answer keys.

Start Generating Free

Similar questions

What is being done to change the range of voltmeter?
Explain simple microscope. Obtain the equation of magnification for the image formed at near point.
A convex lens of refractive index 1.5 has a focal length of 18cm in air. Calculate the change in its focal length when it is immersed in water of refractive index $\frac{4}{3}$
A Galilean telescope is 27cm long when focused to form an image at infinity. If the objective has a focal length of 30cm, what is the focal length of the eyepiece?
The circuit arrangement given below shows that when an a.c. passes through the coil A, the current starts flowing in the coil B.
  1. State the underlying principle involved.
  2. Mention two factors on which the current produced in the coil B depends.
Identify the logic gates marked 'P' and 'Q' in the given circuit. Write the truth table for the combination.
Write a short note on $X-$ rays.
A parallel beam of monochromatic light falls normally on a single narrow slit. How does the angular width of the principal maximum in the resulting diffraction pattern depend on the width of the slit?
Because of the friction between the water in oceans with the earth's surface, the rotational kinetic energy of the earth is continuously decreasing. If the earth's angular speed decreases by 0.0016rad/ day in 100 years, find the average torque of the friction on the earth. Radius of the earth is 6400km and its mass is $6.0 × 10^{24}$kg.
The charge on a proton is $+1.6 \times 10^{-19} \mathrm{C}$ and that on an electron is $-1.6 \times 10^{-19} \mathrm{C}$. Does it mean that the electron has a charge $3.2 \times 10^{-19} \mathrm{C}$ less than the charge of a proton?