MCQ
A light wave is incident normally over a slit of width $24\times 10^{-5}\ cm$. The angular position of second dark fringe from the central maxima is $30^\circ$. What is the wavelength of light
  • $6000 \mathring A$
  • B
    $5000 \mathring A$
  • C
    $3000 \mathring A$
  • D
    $1500 \mathring A$

Answer

Correct option: A.
$6000 \mathring A$
$6000 \mathring A$

Need a full question paper?

Generate a complete, print-ready paper with questions like this in minutes — across 16+ boards, with answer keys.

Start Generating Free

Similar questions

The resistance of a galvanometer is 90 ohms. If only 10 percent of the main current may flow through the galvanometer, in which way and of what value, a resistor is to be used(a) 10 ohms in series(b) 10 ohms in parallel(c) 810 ohms in series(d) 810 ohms in parallel
   
   
To convert a $800\ mV$ range milli voltmeter of resistance $40\Omega$ into a galvanometer of $100\ mA$ range, the resistance to be connected as shunt is
For a fast chain reaction, the size of $U^{235 }$ block, as compared to its critical size, must be:
1 nano farad =
In Young’s double slit experiment, the two slits act as coherent sources of equal amplitude A and wavelength l. In another experiment with the same set up the two slits are of equal amplitude A and wavelength l but are incoherent. The ratio of the intensity of light at the mid-point of the screen in the first case to that in the second case is(a) 1 : 2   (b) 2 : 1(c) 4 : 1    (d) 1 : 1
       
In the given figure each plate of capacitance $C$ has partial value of charge
When we touch the terminals of a high voltage capacitor, even after a high voltage has been cut off, then the capacitor has a tendency to(a) Restore energy(b) Discharge energy(c) Affect dangerously(d) Both (b) and (c)
       
A current passes through a resistor. If $K_1$ and $K_2$ represent the average kinetic energy of the conduction electrons and the metal ions respectively then:
Which of the following cannot be used in electronic devices?
The equation of an alternating voltage is E = 220 E = 220.Then the impedance of the circuit is: