MCQ
A parallel plate capacitor with air as medium between the plates has a capacitance of 10 μF. The area of capacitor is divided into two equal halves and filled with two media as shown in the figure having dielectric constant $\mathrm{k}_1=2$ and $\mathrm{k}_2=4$. The capacitance of the system will now be
  • A
    10 μF
  • B
    20 μF
  • 30 μF
  • D
    40 μF

Answer

Correct option: C.
30 μF
(c) 30 μF

Need a full question paper?

Generate a complete, print-ready paper with questions like this in minutes — across 16+ boards, with answer keys.

Start Generating Free

Similar questions

Which of the following particles are constituents of the nucleus
A $0.07\,{H}$ inductor and a $12 \,\Omega$ resistor are connected in series to a $220 \,{V}, 50 \,{Hz}$ ac source. The approximate current in the circuit and the phase angle between current and source voltage are respectively. [Take $\pi$ as $\left.\frac{22}{7}\right]$
The correct relation between limit of resolution and resolving power is
Alnico is used for making permanent magnets because it has:
Assertion : Four point charges $q_1,$ $q_2$, $q_3$ and $q_4$ are as shown in figure. The flux over the shown Gaussian surface depends only on charges $q_1$ and $q_2$.

Reason : Electric field at all points on Gaussian surface depends only on charges $q_1$ and $q_2$ .

The V-i graph for a conductor makes an angle θ with V-axis. Here V denotes the voltage and i denotes current. The resistance of conductor is given by
A thin metallic wire having cross sectional area of $10^{-4} \mathrm{~m}^2$ is used to make a ring of radius $30 \mathrm{~cm}$. A positive charge of $2 \pi \mathrm{C}$ is uniformly distributed over the ring, while another positive charge of $30$ $\mathrm{pC}$ is kept at the centre of the ring. The tension in the ring is__________ $\mathrm{N}$; provided that the ring does not get deformed (neglect the influence of gravity). (given, $\frac{1}{4 \pi \in_0}=9 \times 10^9 \mathrm{SI}$ units)
In the following diagram the work done in moving a point charge from point $P$ to point $A$, $B$ and $C$ is respectively as $W_A$, $W_B$ and $W_C$ , then
Vibration magnetometer is used for comparing
A solid sphere, a hollow sphere and a disc, all having same mass and radius, are placed at the top of an incline and released. The friction coefficients between the objects and the incline are same and not sufficient to allow pure rolling. Least time will be taken in reaching the bottom by: