MCQ
A spherical ball of radius $1 \times 10^{-4} \mathrm{~m}$ and density $10^5$ $\mathrm{kg} / \mathrm{m}^3$ falls freely under gravity through a distance $h$ before entering a tank of water, If after entering in water the velocity of the ball does not change, then the value of $h$ is approximately:

(The coefficient of viscosity of water is $9.8 \times 10^{-6}$ $\left.\mathrm{N} \mathrm{s} / \mathrm{m}^2\right)$

  • A
    $2296 \mathrm{~m}$
  • B
    $2249 \mathrm{~m}$
  • $2518 \mathrm{~m}$
  • D
    $2396 \mathrm{~m}$

Answer

Correct option: C.
$2518 \mathrm{~m}$
c
$V_T=\frac{2 g}{9} \frac{R^2\left[\rho_B-\rho_L\right]}{\eta}$

$\Rightarrow V_T=\frac{2}{9} \times \frac{10 \times\left(10^{-4}\right)^2}{9.8 \times 10^{-6}}\left[10^5-10^3\right]$

$\Rightarrow V_T=224.5$

when ball fall from height ($h$)

$\mathrm{V}=\sqrt{2 \mathrm{gh}}$

$\mathrm{h}=\left(\frac{\mathrm{V}^2}{2 \mathrm{~g}}\right)=2518 \mathrm{~m}$

Need a full question paper?

Generate a complete, print-ready paper with questions like this in minutes — across 16+ boards, with answer keys.

Start Generating Free

Similar questions

A cart is moving with a velocity $20\,m/s$. Sand is being dropped into the cart at the rate of $50\, kg/min$. The force required to move the cart with constant velocity will be ............ $N$
The temperature of an object is observed to rise in a period. In this period:
  1. Heat is certainly supplied to it.
  2. Heat is certainly not supplied to it.
  3. Heat may have been supplied to it.
  4. Work may have been done on it.
If the coefficient of restitution be $0.5,$ what is the percentage loss of energy on each rebounding of a ball dropped from a height ............ $\%$
For any $S.H.M.$, amplitude is $6\, cm$. If instantaneous potential energy is half the total energy then distance of particle from its mean position is .... $cm$
A block of mass $m$ slides along a floor while a force of magnitude $F$ is applied to it at an angle $\theta$ as shown in figure. The coefficient of kinetic friction is $\mu_{ K }$. Then, the block's acceleration $'a'$ is given by: ($g$ is acceleration due to gravity)
A disc of radius $1\,m$ and mass $4\,kg$ rolls on a horizontal plane without slipping in such a way that its centre of mass moves with a speed of $10\,cm/\sec .$ Its rotational kinetic energy is
A number of holes are drilled along a diameter of a disc of radius $R$. To get minimum time period of oscillations the disc should be suspended from a horizontal axis passing through a hole whose distance from the centre should be 
Three conducting rods of same material and cross-section are shown in figure. Temperatures of$ A, D$ and $C$ are maintained at $20^o C, 90^o C$ and $0^o C$. The ratio of lengths of $BD$ and $BC$ if there is no heat flow in $AB$ is:
An object will not undergo rotational motion when:
A wheel is rotating about an axis through its centre at $720\, rpm$. It is acted on by a constant torque opposing its motion for $8\, seconds$ to bring it to rest finally. The value of torque (in $N-m$) is  (Given $I = \frac{{24}}{\pi }kg - {m^2}$ )