MCQ
Boron rods in nuclear reactor are used as a
  • A
    Moderator
  • Control rods
  • C
    Coolants
  • D
    Protective shield

Answer

Correct option: B.
Control rods
b
(b) Control rods are used in nuclear reactors to control the fission rate of uranium and plutonium. It is achieved by removing the excess neutrons from the reactor core. The only way to remove the excess neutrons through some elements which posses strong neutron absorption capacity. One such element is boron. By regulating the movement or insertion of boron rods into the reactor core while fission process is in progress, the excess neutrons produced during the chain reaction are absorbed by boron which rods regulate the availability of neutron.

Need a full question paper?

Generate a complete, print-ready paper with questions like this in minutes — across 16+ boards, with answer keys.

Start Generating Free

Similar questions

An electromagnetic wave of frequency $\nu = 3.0\,MHz$ passes from vacuum into a dielectric medium with permitivity $\varepsilon = 4.0$. Then
A hydrogen atom is in ground state. In order to get six lines in its emission spectrum, wavelength of incident radiation should be .......... $\mathring A$
A stream of a positively charged particles having $\frac{ q }{ m }=2 \times 10^{11} \frac{ C }{ kg }$ and velocity $\overrightarrow{ v }_0=3 \times 10^7 \hat{ i ~ m} / s$ is deflected by an electric field $1.8 \hat{ j } kV / m$. The electric field exists in a region of $10 cm$ along $x$ direction. Due to the electric field, the deflection of the charge particles in the $y$ direction is $...........mm$
Half life of a radioactive substance is $T$. The time taken for all the nuclei to disintegrate will be
An electron with kinetic energy $K _{1}$ enters between parallel plates of a capacitor at an angle $'\alpha'$ with the plates. It leaves the plates at angle $' \beta '$ with kinetic energy $K _{2}$. Then the ratio of kinetic energies $K _{1}: K _{2}$ will be ....... .
The figure shows three situations when an electron moves with velocity $\vec v$ travels through a uniform magnetic field $\vec B$. In each case, what is the direction of magnetic force on the electron
In an electric heater 4 amp current passes for 1 minute at potential difference of 250 volt, the power of heater and energy consumed will be respectively
In the figure is shown Young’s double slit experiment.$ Q$ is the position of the first bright fringe on the right side of $O. P$ is the $11^{th}$ fringe on the other side, as measured from $Q$. If the wavelength of the light used is $6000 \times {10^{ - 10}}m$, then ${S_1}B$ will be equal to
The sliding contact $C$ is at one fourth of the length of the potentiometer wire $( AB )$ from $A$ as shown in the circuit diagram. If the resistance of the wire $AB$ is $R _0$, then the potential drop $( V )$ across the resistor $R$ is
The current in a coil changes from $4$ $ampere$ to zero in $0.1$ $s$. If the average $e.m.f. $induced is $100 \,volt$, what is the self inductance of the coil.....$H$