MCQ
Hook's law defines
  • A
    Stress
  • B
    Strain
  • Modulus of elasticity
  • D
    Elastic limit

Answer

Correct option: C.
Modulus of elasticity
c
(c)

Need a full question paper?

Generate a complete, print-ready paper with questions like this in minutes — across 16+ boards, with answer keys.

Start Generating Free

Similar questions

A copper rod of length $l_1$ and an iron rod of length $l_2$ are always maintained at the same common temperature $T$. If the difference $(l_2 -l_1)$ is $15\,cm$ and is independent of the value of $T,$ the $l_1$ and $l_2$ have the values (given the linear coefficient of expansion for copper and iron are $2.0 \times 10^{-6}\,C^{-1}$ and $1.0\times10^{-6}\,C^{ -1}$  respectively)
In the figure, the position-time graph of a particle of mass $0.1\, kg$ is shown. The impulse at $t = 2\, second$ is ......... $kg\,ms^{-1}$
The velocity $v$ of a particle as a function of its position $(x)$ is expressed as $v=\sqrt{c_1-c_2 x}$, where $c_1$ and $c_2$ are positive constants. The acceleration of the particle is
A gas is compressed adiabatically till its temperature is doubled. The ratio of its final volume to initial volume will be
A glass flask of volume one litre at $0^oC$ is filled, level full of mercury at this temperature. The flask and mercury are now heated to $100°C$ ........... $cc$ mercury will spill out, if coefficient of volume expansion of mercury is $1.82 \times {10^{ - 4}}°C^{-1}$ and linear expansion of glass is $0.1 \times {10^{ - 4}}°C^{-1}$ respectively
An arrow is shot into air. Its range is $200\,m$ and its time of flight is $5\,s$. If $g=10\,m / s ^2$, then horizontal component of velocity and the maximum height will be respectively
In an experiment to determine the acceleration due to gravity $g$, the formula used for the time period of a periodic motion is $T=2 \pi \sqrt{\frac{7(R-r)}{5 g}}$. The values of $R$ and $r$ are measured to be $(60 \pm 1) \mathrm{mm}$ and $(10 \pm 1) \mathrm{mm}$, respectively. In five successive measurements, the time period is found to be $0.52 \mathrm{~s}, 0.56 \mathrm{~s}, 0.57 \mathrm{~s}, 0.54 \mathrm{~s}$ and $0.59 \mathrm{~s}$. The least count of the watch used for the measurement of time period is $0.01 \mathrm{~s}$. Which of the following statement($s$) is(are) true?

($A$) The error in the measurement of $r$ is $10 \%$

($B$) The error in the measurement of $T$ is $3.57 \%$

($C$) The error in the measurement of $T$ is $2 \%$

($D$) The error in the determined value of $g$ is $11 \%$

A body of mass $2\, kg$ is hung on a spring balance mounted vertically in a lift. If the lift descends with an acceleration equal to the acceleration due to gravity $‘g’$, if the lift moves up with an acceleration equal to the acceleration due to gravity, the reading on the spring balance will be .......... $kg$
A uniform bar of square cross-section is lying along a frictionless horizontal surface. A horizontal force is applied to pull it from one of its ends, then:
‘Gulab Jamuns’ (assumed to be spherical) are to be heated in an oven. They are available in two sizes, one twice bigger (in radius) than the other. Pizzas (assumed to be discs) are also to be heated in oven. They are also in two sizes, one twice big (in radius) than the other. All four are put together to be heated to oven temperature. Choose the correct option from the following:
  1. Both size gulab jamuns will get heated in the same time.
  2. Smaller gulab jamuns are heated before bigger ones.
  3. Smaller pizzas are heated before bigger ones.
  4. Bigger pizzas are heated before smaller ones.