The minimum force required to start pushing a body up a rough (fr… - Vidyadip

MCQ

The minimum force required to start pushing a body up a rough (frictional coefficient $\mu$) inclined plane is $F _{1}$ while the minimum force needed to prevent it from sliding down is $F _{2}$. If the inclined plane makes an angle $\theta$ from the horizontal such that $\tan \theta=2 \mu$, then the ratio $\frac{F_{1}}{F_{2}}$ is

A
$4$
B
$1$
C
$2$
✓
$3$

✓

Answer

Correct option: D.

$3$

d
$F _{1}= mg (\sin \theta+\mu \cos \theta)$

$F _{2}= mg (\sin \theta-\mu \cos \theta)$

$\frac{ F _{1}}{ F _{2}}=\frac{\sin \theta+\mu \cos \theta}{\sin \theta-\mu \cos \theta}$

$\frac{ F _{1}}{ F _{2}}=\frac{\tan \theta+\mu}{\tan \theta-\mu}$

$\frac{ F _{1}}{ F _{2}}=\frac{2 \mu+\mu}{2 \mu-\mu}$

$\frac{ F _{1}}{ F _{2}}=3$

Need a full question paper?

Generate a complete, print-ready paper with questions like this in minutes — across 16+ boards, with answer keys.

Start Generating Free

Explore more

JEE STD 11 Science question papers→Gujarat Board STD 11 Science question papers→Gujarat Board question paper generator→

Similar questions

Two forces acting on point $A$ along their side and having magnitude reciprocal to length of side then resultant of these forces will be proportional to

The radius of the first permitted Bohr orbit for the electron, in a hydrogen atom equals $0.51 \mathring A$ and its ground state energy equals $-13.6\; eV$. If the electron in the hyrogen atom is replaced by muon ($\mu^{-}$) [charge same as electron and mass $207 \mathrm{m}_{e}$], the first Bohr radius and ground state energy will be

A thin metallic partition of negligible thickness is inserted between two shaded metallic plates as shown. The remaining ends are then packed with insulating plates to form a container like structure.$2$ taps shown are opened at $t = 0$ and finally closed at $t = 5s$. Find capacitance of system between $A$ and $B$ after closing taps. (Assume liquid to be non conducting) Volumetric flow rates and dieletric constants of liquid are given.

A string is clamed at both the ends and it is vibrating in its $4^{th}$ harmonic. The equation of the stationary wave is $Y =0.3\,sin\,(0.157\,x) \,cos\,(200\pi t)$. The length of the string is ..... $m$ (all quantities are in $SI$ units)

A far off planet is estimated to be at a distance $D$ from the earth. If its diametrically opposite extremes subtend an angle $\theta$ at an observatory situated on the earth, the approximate diameter of the planet is .............

Calculate the acceleration (In $m/s^{2}$) of the block and trolly system shown in the figure. The coefficient of kinetic friction between the trolly and the surface is $0.05 .\left( g =10\; m / s ^{2},\right.$ mass of the string is negligible and no other friction exists).

Three similar wires of frequency $n_1, n_2$ and $n_3$ are joined to make one wire. Its frequency will be

Two resistors of resistances $R_1 = (300 \pm 3) \,\Omega $ and $R_2 = (500 \pm 4)$ are connected in series. The equivalent resistance of the series combination is

Two bodies of different masses ${m_a}$ and ${m_b}$ are dropped from two different heights $a$ and $b$. The ratio of the time taken by the two to cover these distances are

In an $RC$ circuit while charging, the graph of in $i$ versus time is as shown by the dotted line in the diagram figure, where $i$ is the current. When the value of the resistance is doubled, which of the solid curve best represents the variation of in $i$ versus time