Question
The resolving power of a telescope can be increased by increasing:

Answer

  1. Diameter of objective.
Explanation:
The resolving power of a telescope can be given as:
Resolving power $=\frac{1}{\text{d}(\theta)}=\frac{1}{1.22\lambda/ \text{D}}=\frac{\text{D}}{1.22}$ (wavelength)
So, resolving power can be increased by decreasing the wavelength and increasing the diameter of objective.

Need a full question paper?

Generate a complete, print-ready paper with questions like this in minutes — across 16+ boards, with answer keys.

Start Generating Free

Similar questions

Three waves are given below. I. Sound waves, II. Visible light waves, III. X-rays. Which of the above waves cannot be polarised?
A square coil $10^{-2} m^2$  area is placed perpendicular to a uniform magnetic field of intensity $10^3 wb / m ^2$. The magnetic flux through the coil is
A particle of mass m and charge q enters a magnetic field B perpendicularly with a velocity v, The radius of the circular path described by it will be(a) Bq/mv(b) mq/Bv(c) mB/qv(d) mv/Bq
       
In the circuit shown, a meter bridge is in its balanced state. The meter bridge wire has a resistance $0.1\ ohm/cm$. The value of unknown resistance $X$ and the current drawn from the battery of negligible resistance is
In a moving cell galvanometer, we use a radial magnetic field so that the galvanometer scale is:
The continuous $x-$ray spectrum obtained from a Coolidge tube is of the form
The electromagnetic waves travel with a velocity(a) Equal to velocity of sound(b) Equal to velocity of light(c) Less than velocity of light(d) None of these
   
   
The capacity of a parallel plate air condenser is 2 μF. If a dielectric of dielectric constant 4 is introduced between the plates, its new capacity is:
According to oersted, around a current carrying conductor, magnetic field exists:
Two conducting circular loops F and G are kept in a plane on either side of a straight current-carrying wire as shown in the figure below. If the current in the wire decreases in magnitude, the induced current in the loops will be.