Question
What is meant by pure and impure spectrum?
✓
Answer
Pure spectrum : When rays of white light pass through a prism, each ray forms a spectrum on the screen. If each colour is seen separately in the spectrum, then this type of spectrum is called 'pure spectrum'. The following are the conditions for obtaining a pure spectrum :
(i) The line aperture should be narrow and located at the focus of the converging lens.
(ii) The prism should be in a position of minimum deviation.
(iii) Rays of the same colour emanating from the prism should be focused at one place by the converging lens.
(iv) The incident rays should be parallel.
Impure spectrum : When rays of white light pass through a prism then each ray produces a spectrum on the screen. Due to overlapping of different colors, these colours are not visible separately on the screen. This type of spectrum is called 'impure spectrum'.
(i) The line aperture should be narrow and located at the focus of the converging lens.
(ii) The prism should be in a position of minimum deviation.
(iii) Rays of the same colour emanating from the prism should be focused at one place by the converging lens.
(iv) The incident rays should be parallel.
Impure spectrum : When rays of white light pass through a prism then each ray produces a spectrum on the screen. Due to overlapping of different colors, these colours are not visible separately on the screen. This type of spectrum is called 'impure spectrum'.
Need a full question paper?
Generate a complete, print-ready paper with questions like this in minutes — across 16+ boards, with answer keys.
Explore more
Similar questions
Two heated wires of the same dimensions are first connected in series and then in parallel to a source of supply. What will be the ratio of heat produced in the two cases?
A thin but long, hollow, cylindrical tube of radius r carries a current i along its length. Find the magnitude of the magnetic field at a distance $\frac{\text{r}}{2}$ from the surface (a) inside the tube (b) outside the tube.
→- Write the basic nuclear process involved in the emission of$\beta^{+}$ in a symbolic form, by a radioactive nuclear.
- in the reactions given below:
- $^{11}_{6}\text{C}\rightarrow ^{\text{z}}_{\text{y}}\text{B} + \text{x} + \text{v}$
- $^{12}_{6}\text{C}\rightarrow ^{12}_{6}\text{C}\rightarrow^{20}_{\text{a}}\text{Ne} + ^{c}_{b}\text{He}$
Find the values of x,y, and z and a,b and c.
- If one of two identical slits producing interference in Young’s experiment is covered with glass, so that the light intensity passing through it is reduced to 50%, find the ratio of the maximum and minimum intensity of the fringe in the interference pattern.
- What kind of fringes do you expect to observe if white light is used instead of monochromatic light?
In a series LCR circuit connected to an ac source of variable frequency and voltage v vm= sin, draw a plot showing the variation of current (I) with angular frequency ($\omega$) for two different values of resistance R1 and R2(R1 > R2 ). Write the condition under which the phenomenon of resonance occurs. For which value of the resistance out of the two curves, a sharper resonance is produced? Define Q-factor of the circuit and give its significance.
Explain the difficulties occurred by using galvanometer directly as ammeter.
An air-cored solenoid with length 30cm, area of cross-section 25cm2 and number of turns 500, carries a current of 2.5A. The current is suddenly switched off in a brief time of 10–3s. How much is the average back emf induced across the ends of the open switch in the circuit? Ignore the variation in magnetic field near the ends of the solenoid.
Consider the changes $q, q$ and $-q$ placed at the vertices of an equilateral triangle as shown in figure. What is the foree on each charge ?
→Find the charge on the capacitor shown in figure.
Write relation between $B , H , I , \chi$ and $\mu$.
→