Question
A ray passes through a prism of angle 60° in minimum deviation position and suffers a deviation of 30°. What is the angle of incidence on the prism(a) 30°(b) 45°(c) 60°(d) 90°
✓
Answer
(b) 45°
Need a full question paper?
Generate a complete, print-ready paper with questions like this in minutes — across 16+ boards, with answer keys.
Explore more
Similar questions
Two wires A and B of same material and mass have their lengths in the ratio 1 : 2. On connecting them to the same source, the rate of heat dissipation in B is found to be 5W. The rate of heat dissipation in A is(a) 10W (b) 5W(c) 20W (d) None of these
5 amperes of current is passed through a metallic conductor. The charge flowing in one minute in coulombs will be(a) 5 (b) 12(c) 1/12(d) 300
In an amplifier the load resistance $R_l$ is equal to the plate resistance $\left(r_p\right)$. The voltage amplification is equal to
→There will be no force between two wires carrying currents if currents are:
In the given figure, the equivalent resistance between the points $A$ and $B$ is
→The x-component of the resultant of several vectors:
- Is equal to the sum of the x-components of the vectors.
- May be smaller than the sum of the magnitudes of the vectors.
- May be greater than the sum of the magnitudes of the vectors.
- May be equal to the sum of the magnitudes of the vectors.
The resistivity of iron is $1 \times 10^{-7}$ ohm $- m$. The resistance of a iron wire of particular length and thickness is $1$ ohm . If the length and the diameter of wire both are doubled, then the resistivity in ohm $- m$ will be
→On dividing any magnet of magnetic moment (M) parallel to its length into n equal pieces, the moment of each piece will be :
A long, straight wire carries a current i. The magnetizing field intensity H is measured at a point P close to the wire. A long, cylindrical iron rod is brought close to the wire so that the point P is at the centre the rod. The value of H at P will:
If potential V = 100 ± 0.5 Volt and current I = 10 ± 0.2 amp are given to us. Then what will be the value of resistance(a) 10 ± 0.7 ohm (b) 5 ± 2 ohm(c) 0.1 ± 0.2 ohm(d) None of these