MCQ
For the production of $X$-rays, the target should be made of
- ASteel
- BCopper
- CAluminum
- ✓Tungsten
✓
Answer
Correct option: D.
Tungsten
Target should be of high atomic number and high melting point
Need a full question paper?
Generate a complete, print-ready paper with questions like this in minutes — across 16+ boards, with answer keys.
Explore more
Similar questions
The maximum energy in the thermal radiation from a hot source occurs at a wavelength of $11 \times 10^{-5} \mathrm{~cm}$. According to Wein's law, the temperature of the source (on Kelvin scale) will be $n$ times the wavelength at maximum energy is $5.5 \times 10^{-5} \mathrm{~cm}$. The value $n$ is temperature of another source (on Kelvin scale) for which the
→If two metallic plates of equal thicknesses and thermal conductivities $K_1$ and $K_2$ are put together face to face and a common plate is constructed, then the equivalent thermal conductivity of this plate will be
→The volume of a gas is reduced adiabatically to $\frac{1}{4}$ of its volume at $27^{\circ} \mathrm{C}$, if the value of $\gamma=1.4$, then the new temperature will be
→A body of mass $0.1 \mathrm{~kg}$ moving with a velocity of $10 \mathrm{~m} / \mathrm{s}$ hits a spring (fixed at the other end) of force constant $1000 \mathrm{~N} / \mathrm{m}$ and comes to rest after compressing the spring. The compression of the spring is
→An insulator container contains 4 moles of an ideal diatomic gas at temperature $T$. Heat $Q$ is supplied to this gas, due to which 2 moles of the gas are dissociated into atoms but temperature of the gas remains constant. Then
→An alternating e.m.f. of frequency $v\left(=\frac{1}{2 \pi \sqrt{L C}}\right)$ is applied to a series $\text{LCR}$ circuit. For this frequency of the applied e.m.f.
→A prism of refracting angle 60 is made with a material of refractive index $\mu$. For a certain wavelength of light, the angle of minimum deviation is $30.$ For this, wavelength the value of refractive index of the material is
→An electric motor exerts a force of $40 \mathrm{~N}$ on a cable and pulls it by a distance of $30 \mathrm{~m}$ in one minute. The power supplied by the motor (in Watts) is
→An ideal heat engine working between temperature $T$ and $T$ has an efficiency $\eta$, the new efficiency if both the source and sink temperature are doubled, will be
→Following figure shows cross-sections through three long conductors of the same length and material, with square cross-section of edge lengths as shown. Conductor $B$ will fit snugly within conductor $A$, and conductor $C$ will fit snugly within conductor $B$. Relationship between their end to end resistance is
→