Question
Volt-second is unit of which physical quantity?
✓
Answer
From $\varepsilon=\frac{\Delta \phi}{\Delta t }, \Delta \phi=\varepsilon \times \Delta t$
$\begin{array}{l} \text { Unit of magnetic flux }=\text { Unit of induced emf } \varepsilon \times \text { unit } \\ \text { of time }\end{array}$
$\begin{array}{l} \text { Unit of magnetic flux }=\text { Unit of induced emf } \varepsilon \times \text { unit } \\ \text { of time }\end{array}$
Need a full question paper?
Generate a complete, print-ready paper with questions like this in minutes — across 16+ boards, with answer keys.
Explore more
Similar questions
In the given figure, magnitude of current is increasing in the wire xy from x to y . Is there any induced current in a loop placed near the wire?
The charging current for a capacitor is 0.25 A. What is the displacement current across its plates?
What is called depletion region?
To measure the magnetic moment of a bar magnet, one may use:
- A tangent galvanometer.
- A deflection galvanometer if the earth's horizontal field is known.
- An oscillation magnetometer if the earth's horizontal field is known.
- Both deflection and oscillation magnetometer if the earth's horizontal field is not known.
If the magnetic field is parallel to the positive $y$-axis and the charged particle is moving along the positive $x$-axis (Fig. 4.4), which way would the Lorentz force be for (a) an electron (negative charge), (b) a proton (positive charge).
→For a transistor amplifier, the voltage gain,
- Remains constant for all frequencies.
- Is high at high and low frequencies and constant in the middle frequency range.
- Is low at high and low frequencies and constant at mid frequencies.
- None of the above.
Can the peak voltage across the inductor be greater than the peak voltage of the source in an LCR circuit?
Does the magnifying power of a microscope depend on the colour of the light used? Justify your answer.
Suppose you have three resistors, each of value $30\Omega.$ List all the different resistances you can obtain using them.
→Water flows through a tube shown in The areas of cross-section at A and B are 1cm2 and 0.5cm2 respectively. The height difference between A and B is 5cm. If the speed of water at A is 10cm/s find.
- The speed at B.
- The difference in pressures at A and B.