Question
When we stir a liquid vigorously, it becomes warm. Is it a reversible process?

Answer

When we stir a liquid vigorously, we do work on it due to which its temperature rises and it becomes warm. To bring back the liquid to the initial temperature, heat needs to be extracted from it. But it is an irreversible process that cannot be brought back to the initial state by stirring the liquid again in the opposite direction.

Need a full question paper?

Generate a complete, print-ready paper with questions like this in minutes — across 16+ boards, with answer keys.

Start Generating Free

Similar questions

The two specific heat capacities of a gas are measured as $\text{C}_\text{p} = (12.28 \pm 0.2) $ units and $\text{C}_\text{v} = (3.97 \pm 0.3)$ units. Find the value of the gas constant R.
A block of mass 100g is moved with a speed of 5.0m/s at the highest point in a closed circular tube of radius 10cm kept in a vertical plane. The cross-section of the tube is such that the block just fits in it. The block makes several oscillations inside the tube and finally stops at the lowest point. Find the work done by the tube on the block during the process.
A ball of mass 0.50kg moving at a speed of 5.0m/s collides with another ball of mass 1.0kg. After the collision the balls stick together and remain motionless. What was the velocity of the 1.0kg block before the collision?
The speed of light in glass is 2.0 × 101m/s. Does it violate the second postulate of special relativity?
A car starting from rest, accelerates at the rate f through a distances, then continues at constant speed for sometimet and then decelerate at the rate $\frac{\text{f}}{2}$ to come to rest. If the total distance is 5s, then prove that $\text{s}=\frac{1}{2}\text{ft}^2.$
Discuss the variation of 'g' with depth. What happens to 'g' at the centre of earth?
If $\text{x = a}\cos\omega\text{t + b}\sin\omega\text{t},$ show that it represents S.H.M. 
Find the ratio of units of viscosity coefficient in the M.K.S. and C.G.S. system
A plate of area 10cm2 is to be electroplated with copper (density 9000kg/m3) to a thickness of 10 micrometres on both sides, using a cell of 12V. Calculate the energy spent by the cell in the process of deposition. If this energy is used to heat 100g of water, calculate the rise in the temperature of the water. ECE of copper = 3 × 10-7kg C-1 and specific heat capacity of water = 4200Jkg-1.
Why is it not possible to make permanent magnets from paramagnetic materials?