A travelling microscope has $20$ divisions per $cm$ on the main scale while its Vernier scale has total $50$ divisions and $25$ Vernier scale divisions are equal to $24$ main scale divisions, what is the least count of the travelling microscope $..........\,cm$
JEE MAIN 2022, Medium
Download our appand get started for free
Experience the future of education. Simply download our apps or reach out to us for more information. Let's shape the future of learning together!No signup needed.*
Similar Questions
- 1View SolutionWhich of the following is not the unit of energy
- 2View SolutionCandela is the unit of
- 3Match List - $I$ with List - $II$.View Solution
List - $I$ $(Number)$ $List - II$ $(Significant figure)$ $(A)$ $1001$ $(I)$ $3$ $(B)$ $010.1$ $(II)$ $4$ $(C)$ $100.100$ $(III)$ $5$ $(D)$ $0.0010010$ $(IV)$ $6$ Choose the correct answer from the options given below :
- 4The dimensions of $emf$ in $MKS$ isView Solution
- 5The vernier scale used for measurement has a positive zero error of $0.2\, mm$. If while taking a measurement it was noted that $'0'$ on the vernier scale lies between $8.5\, cm$ and $8.6\, cm$ vernier coincidence is $6,$ then the correct value of measurement is ............. $cm$. (least count $=0.01\, cm )$View Solution
- 6If we use permittivity $ \varepsilon $, resistance $R$, gravitational constant $G$ and voltage $V$ as fundamental physical quantities, thenView Solution
- 7A torque meter is calibrated to reference standards of mass, length and time each with $5 \%$ accuracy. After calibration, the measured torque with this torque meter will have net accuracy of$............\%$View Solution
- 8Area of the cross-section of a wire is measured using a screw gauge. The pitch of the main scale is $0.5 mm$. The circular scale has 100 divisions and for one full rotation of the circular scale, the main scale shifts by two divisions. The measured readings are listed below.View Solution
Measurement condition Main scale reading Circular scale reading Two arms of gauge touching each other without wire $0$ division $4$ division Attempt-$1$: With wire $4$ division $20$ division Attempt-$2$: With wire $4$ division $16$ division What are the diameter and cross-sectional area of the wire measured using the screw gauge?
- 9The speed of a wave produced in water is given by $v=\lambda^a g^b \rho^c$. Where $\lambda$, g and $\rho$ are wavelength of wave, acceleration due to gravity and density of water respectively. The values of $a , b$ and $c$ respectively, areView Solution
- 10View SolutionThe foundations of dimensional analysis were laid down by