In the following $'I'$ refers to current and other symbols have their usual meaning, Choose the option that corresponds to the dimensions of electrical conductivity
  • A$M^{-1} L^{-3}T^3I$
  • B$M^{-1}L^{-3}T^3I^2$
  • C$M^{-1}L^3T^3I$
  • D$ML^{-3}T^{-3}I^2$
JEE MAIN 2016, Medium
art

Download our app
and get started for free

Experience the future of education. Simply download our apps or reach out to us for more information. Let's shape the future of learning together!No signup needed.*

Similar Questions

  • 1
    In the electrical circuit shown in the figure, the current $i$ through the side $AB$ is
    View Solution
  • 2
    By a cell a current of $0.9\, A$ flows through $2\, ohm$ resistor and $0.3\,A$ through $7\, ohm$ resistor. The internal resistance of the cell is ............ $\Omega$
    View Solution
  • 3
    Assertion : Kirchoff 's junction rule follows from conservation of charge.

    Reason : Kirchoff 's loop rule follows from conservation of momentum.

    View Solution
  • 4
    The equivalent resistance between $A$ and $B$ of the network shown in figure
    View Solution
  • 5
    The resistance of hot tungsten filament is about $10$ times the cold resistance. What will be the resistance of $100\, W$ and $200\, V$ lamp when not in use ............. $\Omega $
    View Solution
  • 6
    If a wire of resistance $R$ is melted and recasted to half of its length, then the new resistance of the wire will be
    View Solution
  • 7
    A potential divider is used to give outputs of $4\, V$ and $8\, V$ from a $12\, V$ source. Which combination of resistances, $(R_1, R_2, R_3)$ gives the correct voltages ? $R_1 : R_2 : R_3$
    View Solution
  • 8
    $A$ total charge $Q$ flows across a resistor $R$ during a time interval $= T$ in such a way that the current vs. time graph for $0 \rightarrow T$ is like the loop of a sin curve in the range $0 \rightarrow \pi$ . The total heat generated in the resistor is
    View Solution
  • 9
    Four wires of equal length and of resistances $10$ $ ohms$ each are connected in the form of a square. The equivalent resistance between two opposite corners of the square is ............. $ohm$
    View Solution
  • 10
    It is preferable to measure the $e.m.f.$ of a cell by potentiometer than by a voltmeter because of the following possible reasons.
    $(i)$ In case of potentiometer, no current flows through the cell.
    $(ii)$ The length of the potentiometer allows greater precision.
    $(iii)$ Measurement by the potentiometer is quicker.
    $(iv)$ The sensitivity of the galvanometer, when using a potentiometer is not relevant.
    Which of these reasons are correct?
    View Solution