Question
The amplification factor of a triode operating in the linear region depends strongly on:
  1. The temperature of the cathode.
  2. The plate potential.
  3. The grid potential.
  4. The separations of the grid from the cathode and the anode.

Answer

  1. The separations of the grid from the cathode and the anode.

Explanation:

When the triode operating in the linear region, value of plate voltage, grid voltage and plate current is already specified (or fixed). If the grid is near the cathode, then we assume that grid lie in the region where the space charge density is more. There is a chance that grid will pick up electrons from the space charge region of cathode and effect the plate current and hence amplification factor (as we know that amplification factor will depend on the plate current). If the grid is far from the cathode, it will reduce the grid voltage and hence the amplification factor also get affected.

Need a full question paper?

Generate a complete, print-ready paper with questions like this in minutes — across 16+ boards, with answer keys.

Start Generating Free

Similar questions

The US athlete Florence Griffith-Joyner won the 100m sprint gold medal at Seol Olympic 1988 setting a new Olympic record of 10.54s. Assume that she achieved her maximum speed in a very short-time and then ran the race with that speed till she crossed the line. Take her mass to be 50kg.
  1. Calculate the kinetic energy of Griffith-Joyner at her full speed.
  2. Assuming that the track, the wind etc. offered an average resistance of one tenth of her weight, calculate the work done by the resistance during the run.
  3. What power GriffithJoyner had to exert to maintain uniform speed?
In a testing experiment on a model aeroplane in a wind tunnel, the flow speeds on the upper and lower surfaces of the wing are $70 m s ^{-1}$ and 63 m $s^{-1}$ respectively. What is the lift on the wing if its area is $2.5 m^2$ ? Take the density of air to be $1.3 kg m ^{-3}$.
Shows a rod PQ of length 20.0cm and mass 200g suspended through a fixed point O by two threads of lengths 20.0cm each. A magnetic field of strength 0.500T exists in the vicinity of the wire PQ, as shown in the figure. The wires connecting PQ with the battery are loose and exert no force on PQ.
  1. Find the tension in the threads when the switch S is open.
  2. A current of 2.0A is established when the switch S is closed. Find the tension in the threads now.

The plate current in a triode value is maximum when the potential of the grid is:
  1. Positive.
  2. Zero.
  3. Negative.
  4. Non-positive.
Let i0 be the thermionic current from a metal surface when the absolute temperature of the surface is T0. The temperature is slowly increased and the thermionic current is measured as a function of temperature. Which of the following plots may represent the variation in $\Big(\frac{\text{i}}{\text{i}_0}\Big)$ against $\Big(\frac{\text{T}}{\text{T}_0}\Big)?$

How will you ‘weigh the sun’, that is estimate its mass ? The mean orbital radius of the earth around the sun is 1.5 × 108 km.
A lady cannot see objects closer than 40cm from the left eye and closer than 100cm from the right eye. While on a mountaineering trip, she is lost from her team. She tries to make an astronomical telscope from her reading glasses to look for her teammates.
  1. Which glass should she use as the eyepiece?
  2. What magnification can she get with relaxed eye?
An AC source is connected to a diode and a resistor in series. Is the current thorough the resistor AC or DC?
A hot body is placed in a closed room maintained at a lower temperature. Is the number of photons in the room increasing?
A body of mass 5 kg is acted upon by two perpendicular forces 8 N and 6 N. Give the magnitude and direction of the acceleration of the body.