Question
The photons of continuous frequency range are passing through rarafied hydrogen pattern. Three absorbed lines are shown in Fig.
Image
(i) To which series of hydrogen spectrum, these lines are related?
(ii) Out of them which has maximum wavelength?

Answer

(i) I = Lyman series, II = Balmer series, III = Paschen series.
(ii) Since $\lambda=\frac{h c}{\Delta E }$; For maximum wavelength, $\Delta E$ should be minimum. It is for III line. So its wavelength will be maximum.

Need a full question paper?

Generate a complete, print-ready paper with questions like this in minutes — across 16+ boards, with answer keys.

Start Generating Free

Similar questions

The pressure measured by a constant volume gas thermometer is 40kPa at the triple point of water. What will be the pressure measured at the boiling point of water (100°C)?
The magnetic field inside a tightly wound, long solenoid is $\text{B}=\mu_0\text{ni}.$ It suggests that the field does not depend on the total length of the solenoid, and hence if we add more loops at the ends of a solenoid the field should not increase. Explain qualitatively why the extra-added loops do not have a considerable effect on the field inside the solenoid.
Write relation between conductivity and mobility of metal.
Describe schematically the equipotential surfaces corresponding to:
  1. a constant electric field in the z-direction.
  2. a field that uniformly increases in magnitude but remains in a constant (say, z) direction.
  3. a single positive charge at the origin, and.
  4. a uniform grid consisting of long equally spaced parallel charged wires in a plane.
A parallel beam of light of wavelength 500 nm falls on a narrow slit and the resulting diffraction pattern is observed on a screen 1 m away. It is observed that the first minimum is at a distance of 2.5 mm from the centre of the screen. Find the width of the slit.
Draw the output waveform across the resistor (Fig).

Consider the situation shown in figure. Initially the spring is unstretched when the system is released from rest. Assuming no friction in the pulley, find the maximum elongation of the spring.

Figure shows a conducting square loop placed parallel to the pole faces of a ring magnet. The Pole-faces have an area of 1cm2 each and the field between the poles is 0.10T. The wires making the loop are all outside the magnetic field. If the magnet is removed in 1.0s, what is the average emf induced in the loop?

If the intensity of light falling on a metal plate is doubled, what will be the effect on photocurrent and maximum kinetic energy of emitted photoelectrons?
A bulb rated 100 W-220 V is connected across 240 volt. Calculate electric power loss.