Given : $\sigma$ is the compressibility of water, $\rho$ is the density of water and $K$ is the  bulk modulus of water. What is the energy density of water at the bottom of a lake $‘h’$  metre deep ?
  • A$\frac{1}{2}\sigma {(h\rho g)^2}$
  • B$\frac{1}{2}\sigma {(h\rho g)}$
  • C$\frac{1}{2}\frac{{h\rho g}}{\sigma }$
  • D$\frac{{h\rho g}}{\sigma }$
Diffcult
art

Download our app
and get started for free

Experience the future of education. Simply download our apps or reach out to us for more information. Let's shape the future of learning together!No signup needed.*

Similar Questions

  • 1
    A copper wire of length $1.0\, m$ and a steel wire of length $0.5\, m$ having equal cross-sectional areas are joined end to end. The composite wire is stretched by a certain load which stretches the copper wire by $1\, mm$. If the Young's modulii of copper and steel are respectively $1.0\times10^{11}\, Nm^{-2}$ and $2.0\times10^{11}\, Nm^{- 2}$, the total extension of the composite wire is ........ $mm$
    View Solution
  • 2
    On all the six surfaces of a unit cube, equal tensile force of $F$ is applied. The increase in length of each side will be ($Y =$ Young's modulus, $\sigma $= Poission's ratio)
    View Solution
  • 3
    The interatomic distance for a metal is $3 \times {10^{ - 10}}\,m$. If the interatomic force constant is $3.6 \times {10^{ - 9}}\,N/{{\buildrel _{\circ} \over {\mathrm{A}}}}$, then the Young's modulus in $N/{m^2}$ will be
    View Solution
  • 4
    A metal wire of length $'L'$ is suspended vertically from a rigid support. When a body  of mass $M$ is attached to the lower end of wire, the elongation in wire is $'l'$, consider the following statements 

    $(I)$  the loss of gravitational potential energy of mass $M$ is $Mgl$

    $(II)$ the elastic potential energy stored in the wire is $Mgl$

    $(III)$ the elastic potential energy stored in wire is $\frac{1}{2}\, Mg l$

    $(IV)$ heat produced is $\frac{1}{2}\, Mg l$ 

    Correct statement are :-

    View Solution
  • 5
    The Bulk Modulus for an incompressible liquid is
    View Solution
  • 6
    In the below graph, point $B$ indicates
    View Solution
  • 7
    The stress-strain curves for brass, steel and rubber are shown in the figure. The lines $A, B$ and $C$ are for
    View Solution
  • 8
    A certain pressure $P$ is applied to $1$ litre of water and $2$ litre of a liquid separately. Water gets compressed to $0.01 \%$ whereas the liquid gets compressed to $0.03 \%$. The ratio of Bulk modulus of water to that of the liquid is $\frac{3}{x}$. The value of $x$ is $...........$
    View Solution
  • 9
    Young’s moduli of two wires $A$ and $B$ are in the ratio $7 : 4$. Wire $A$ is $2\, m$ long and has radius $R$. Wire $A$ is $2\, m$ long and has radius $R$. Wire $B$ is $1.5\, m$ long and has radius $2\, mm$. If the two wires stretch by the same length for a given load, then the value of $R$ is close to ......... $mm$
    View Solution
  • 10
    If in case $A$, elongation in wire of length $L$ is $l$, then for same wire elongation in case $B$ will be ......
    View Solution