MCQ
If a full wave rectifier circuit is operating from $50\, Hz$ mains, the fundamental frequency in the ripple will be........$Hz$
  • A
    $50$
  • B
    $70.7 $
  • $100$
  • D
    $25$

Answer

Correct option: C.
$100$
c
(c)In full wave rectifier, the fundamental frequency in ripple is twice that of input frequency.

Need a full question paper?

Generate a complete, print-ready paper with questions like this in minutes — across 16+ boards, with answer keys.

Start Generating Free

Similar questions

In the circuit shown in the figure $K_1$ is open. The charge on capacitor $C$ in steady state is $q_1$. Now key is closed and at steady state charge on $C$ is $q_2$. The ratio of charges $q_1/q_2$ is
A compound microscope has magnifying power $30$. The focal length of its eye piece is $5\, cm$. Assuming the final image to be at the least distance of distinct vision. The magnification produced by the objective is
How much positive and negative charge is there in a cup of water $(250\;gm)$?
A thin semicircular conducting ring of radius $R$ is falling with its plane vertical in a horizontal magnetic induction $B$. At the position $MNQ$, the speed of the ring is $V$ and the potential difference developed across the ring is
The ionisation potential of hydrogen atom is $13.6$ volt. The energy required to remove an electron from the second orbit of hydrogen is......$eV$
A charge $Q$ is placed at a distance $a/2$ above the centre of the square surface of edge $a$ as shown in the figure. The electric flux through the square surface is
In a mechanical refrigerator, the low temperature coils are at a temperature of $-23°C$ and the compressed gas in the condenser has a temperature of $27°C.$ The theoretical coefficient of performance is
A pen of mass $m$ is lying on a piece of paper of mass $M$ placed on a rough table. If the coefficients of friction between the pen and paper and the paper and the table are $\mu_1$ and $\mu_2$, respectively. Then, the minimum horizontal force with which the paper has to be pulled for the pen to start slipping is given by
Consider the following statements $(A)$ and $(B)$ and identify the correct answer.

$(A)$ A zener diode is connected in reverse bias, when used as a voltage regulator.

$(B)$ The potential barrier of $\mathrm{p}-\mathrm{n}$ junction lies between $0.1\, \mathrm{~V}$ to $0.3 \,\mathrm{~V}$.

Internal forces acting in a system of particle can change