The equivalent resistance between $A$ and $B$ of the network shown in figure
  • A$11 \frac{2\,R}{3}$
  • B$14\,R$
  • C$21\,R$
  • D$\frac{8}{3}\,R$
JEE MAIN 2023, Medium
art

Download our app
and get started for free

Experience the future of education. Simply download our apps or reach out to us for more information. Let's shape the future of learning together!No signup needed.*

Similar Questions

  • 1
    When cells are connected in parallel, then
    View Solution
  • 2
    A current of $2\,A$ flows in a system of conductors as shown. The potential difference $({V_A} - {V_B})$ will be ............ $V$
    View Solution
  • 3
    In the figure given the value of $X$ resistance will be, when the $p.d.$ between $B$ and $D$ is zero ................... $ohm$
    View Solution
  • 4
    If all the resistors shown have the value $2\, ohm$ each, the equivalent resistance over $AB$ is
    View Solution
  • 5
    The potential difference between $A$ and $B$ in the Figure is ................... $\mathrm{V}$
    View Solution
  • 6
    In the circuit shown here, what is the value of the unknown resistor $R$ so that the total resistance of the circuit between points $P$ and $Q$ is also equal to $R$
    View Solution
  • 7
    How many $60 \,W$ bulbs may be safely run on $220 \,V$ using a $5 \,A$ fuse is .........
    View Solution
  • 8
    When a resistor of $11 \,\Omega$ is connected in series with an electric cell, the current flowing in it is $0.5\, A$. Instead, when a resistor of $5 \,\Omega$ is connected to the same electric cell in series, the current increases by $0.4\, A$. The internal resistance of the cell is ................ $\Omega$
    View Solution
  • 9
    The heating coils rating at $220\, volt$ and producing $50\, cal/sec$ heat are available with the resistances $55\,\Omega $ , $110\,\Omega$ ,  $220\,\Omega $ and $440\,\Omega $. The heater of maximum power will be of............. $\Omega$
    View Solution
  • 10
    Water boils in an electric kettle in $20$ minutes after being switched on. Using the same main supply, the length of the heating element should be. . . . . . .to . . . . . .. times of its initial length if the water is to be boiled in $15$ minutes.
    View Solution